Specifications

IPmux-4 Installation and Operation Manual Appendix E Parameters and Screens
General Configuration E-7
Manager List
The Manager List window parameters are used when IPmux-4 inband
management capability is used. The parameters define the parameters for up to
eight managers. These parameters are:
• Manager IP address
• Host index
In addition, the Manager List window parameters configure the traps to be
received by a manager. The default value for all traps is Off.
The Manager List screen is shown in Figure E-9. Table E-2 lists the Manager List
parameters.
MANAGER LIST
1. Manager IP Address 192.114.35.1
2. Status Change Trap On
3. Alarm Trap On
4. System Trap Off
ESC. Exit S. Save N. Next
After Save: ESC. Exit D. N. Next
Current port is the NETWORK PORT
Select item from the menu: _
Figure E-9. Manager List Window
Table E-2. Manager List Parameters
Key Parameter Possible Values Remarks
1 Manager IP Address 0.0.0.0. to 255.255.255.255
2 Status-Change Trap
On, Off
Informs the manager that a LED indicator on
the front panel has changed its indication.
3 Alarm Trap
On
Off
Informs the manager of the occurrence of any
alarm enabled in the Alarms Trap Mask
screen. It informs the manager of both entry
and exit from an alarm state.
No alarm trap will be sent, regardless of the
Mask defined in the Alarm Trap Mask screen.
4 System Trap
On, Off
Informs the manager whenever there is a
change in the system power-supply status,
heat alarm
Main Menu
↓
2. Configuration
↓
1. General Configuration
↓
3. Management
Configuration
↓
2. Manager List
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com