Specifications

IPmux-4 Installation and Operation Manual Chapter 5 Application Configuration Procedures
IPmux-1 5-9
E1/T1 Configuration
➤
To configure E1/T1:
1. From the Main menu, select 2 Configuration.
2. From the Configuration menu select 2 E1/T1 Configuration (refer to
Figure 5-3).
3. Select Transmit Clock and choose Adaptive.
4. Select Line Type and choose CRC4 Disable.
5. Select Signaling Mode and choose CAS Disable.
6. Press <S> to save the configuration.
7. Press <Esc> a number of times to return to the Configuration screen.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
DS0 Bundle Configuration
➤
To create the bundles:
1. From the Configuration menu select 5 DS0 Bundle Configuration (refer to
Figure 5-4).
2. Select Time slot number and enter 1 – 10.
3. Select Time slot Current Status and choose Set.
4. Press <S> to Save.
5. Press <Esc> to return to the Configuration screen.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
Bundle Connection Configuration
➤
To link the bundles to IPmux-4:
1. From the Configuration menu select 3 Bundle Connection Configuration
(refer to Figure 5-5).
2. Select Connection Status and choose Enable.
3. Select Destination IP Address and enter the IP Address of IPmux-4.
4. Select Next Hop and enter the next hop router IP address (this parameter is
only necessary if the Destination IP Address is not in the same subnet as this
Main Menu
↓
2. Configuration
↓
2. E1/T1
Configuration
Note
Main Menu
↓
2. Configuration
↓
5. DS0 Bundle
Configuration
Note
Main Menu
↓
2. Configuration
↓
3. Bundle
Connection
Configuration
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com