Specifications

Chapter 3 Operation IPmux-4 Installation and Operation Manual
3-4 Getting Started
➤
To set all passwords to the default value (xxxxxxxxxx):
• Enter as su and delete the unit’s configuration through the Configuration
screens.
Deleting the unit’s configuration using <Cntl+A> and choosing 4 in the Boot
Menu does not set the password to the default value.
➤
If a user forgets his password:
• Consult Technical Support at RAD for further assistance (send email to
[e-mail]).
Turning IPmux-4 Off
➤
To power off the unit:
1. If you are using a terminal connection, press escape until you return to the
main menu and press 4. Exit.
2. Switch PS1 (and PS2 if connected) to OFF.
3.4 Getting Started
After installation, there are no special operating procedures for IPmux-4. Once it is
powered up, the unit operates automatically. Proper operation is indicated by the
front-panel LED indicators (Figure 3-1 and Figure 3-2). The unit operational status
can be monitored constantly.
If required, IPmux-4 can be reconfigured. Both the IPmux-4 configuration and
monitoring operations are performed locally from an ASCII terminal connected to
the Control Port. Detailed configuration procedures are given in Section 3.6 and
Appendix E. The following functions are supported:
• View system information
• Modify configuration and mode of operation, including setting system default
values
• View statistics and status
• Perform diagnostics.
IPmux-4 configuration and system monitoring, including troubleshooting
procedures, can also be performed from a remote site using a Telnet application or
RADview (RAD’s HP OpenView based SNMP).
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com