Specifications

Site Requirements and Prerequisites 2-1

Chapter 2

Installation

2.1 Introduction

IPmux-4 is delivered completely assembled for bench-top installation. The only

mechanical installation procedure that may be necessary is optional installation in

a 19" rack. Refer to the Rack Mounting Kit for 19-inch Racks guide that comes with

the RM kit.

After installing the unit, configure the IPmux-4 using an ASCII terminal connected

to the IPmux-4 control port. The IPmux-4 configuration procedures are described

in Chapter 3 of this manual.

If problems are encountered, refer to Chapter 4 for test and diagnostics

instructions.

No internal settings, adjustment, maintenance and repairs may be performed

by either the operator or the user; such activities may be performed only by

skilled service personnel who are aware of the hazards involved.

Always observe standard safety precautions during installation, operation, and

maintenance of this product.

2.2 Site Requirements and Prerequisites

AC-powered IPmux-4 units should be installed within 1.5m (5 feet) of an

easily-accessible grounded AC outlet capable of furnishing the required supply

voltage, in the range of 100 to 240 VAC.

DC-powered IPmux-4 units require a –48 VDC power source.

The DC power source must be isolated from the mains supply by double or

reinforced insulation.

Allow at least 90 cm (36 inches) of frontal clearance for operator access. Allow at

least 10 cm (4 inches) clearance at the rear of the unit for cable connections. Make

sure that the ventilation holes are not blocked.

Warning

Caution

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610