Specifications

IPmux-4 Installation and Operation Manual Chapter 1 Introduction
Technical Specifications 1-17
T1
Framing
Compliance
Framing
Signaling
ANSI T1.403
Passthrough, SF, ESF
CAS (bit robbing), CCS (transparent)
Local
Terminal
and
Control
Interface
Mode
Baud Rate
Connector
RS-232 over RJ-45 (adapter cable to DB-15 supplied)
DTE
9.6, 19.2, 38.4, 57.6 kbps
RJ-45
Dry
Contact
Alarm
Connector
Contacts
DB-9
30V 2A
Ethernet
Modules
Compliance
Connector
Ports
Data Rate
Range
IEEE 802.3, 802.3u, Ethernet, 802.1p&q
RJ-45, 8 pin
1
10 Mbps or 100 Mbps, full or half duplex
Up to 100m over UTP Category 5 cables
General
System Indicators
General:
PS1 ON when main power supply is OK
OFF when a malfunction is detected
PS2 ON when secondary power supply is OK
BLINKS when a malfunction is detected
OFF when secondary power supply does not
exist (no power supply redundancy)
RDY ON when self-test is successfully completed
OFF during self-test
BLINKS when self-test fails
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com