Specifications

Appendix E Parameters and Screens IPmux-4 Installation and Operation Manual
E-24 Bundle Connection Configuration
If Auto Negotiation is set to Enable and there is some incompatibility in the Auto
Negotiation process, Ipmux-4 automatically changes to half-duplex mode. To
overcome this situation, set Auto Negotiation to Disable and set Default type to the
desired mode.
E.6 Bundle Connection Configuration
Parameters must be configured for each connection. To configure all parameters,
first select the bundle ID and then proceed with the parameter configuration.
BUNDLE CONNECTION CONFIGURATION
1. Bundle ID 1
2. Connection Status Disable
3. Destination IP Address 0.0.0.0
4. Next Hop 0.0.0.0
5. Destination Bundle 1
6. Jitter Buffer(x10usec) 300
ESC. Exit
Select item from the menu.
Figure E-23. Bundle Connection Configuration
Table E-15. Bundle Connection Parameters
Key Parameter Possible Values Remarks
1 Bundle ID E1: 1 – 124
T1: 1 – 96
Source Bundle ID
Note: First define the bundle.
2 Connection
Status
Enable
Disable Frames will not be sent on this connection.
3 Destination
IP Address
IP address of the destination device (IPmux-4)
Note: For internal cross-connect, define the destination
IP address as the host address to achieve connectivity between the
source and the destination bundle.
4 Next Hop IP address The ‘next hop’ parameter should be used when the Destination IP
Address is not in the device subnet. In such cases the Ethernet frame
will be sent to the ‘next hop’ IP.
The default value of the next hop field is the default gateway.
Default value: 0.0.0.0 (not configured)
Note: The next hop IP must be in the device subnet.
Note
Main Menu
↓
2. Configuration
↓
5. Bundle Connection
Configuration
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com