Specifications

IPmux-4 Installation and Operation Manual Appendix E Parameters and Screens
LAN Configuration E-23
You cannot change the bundle timeslot(s) if the channel is active. (First disable the
channel via "Bundle Connection Configuration.")
In Bundle Connection Configuration: Deactivate the connection first.
In T1 configuration: Valid timeslots are 1-24.
In E1 configuration: Timeslot 0 is always invalid and timeslot 16 is not valid for
Fractional with CAS.
A list of assigned timeslots (active timeslots in this bundle) and free timeslots on this
link, is shown at the bottom of the menu screen.
E.5 LAN Configuration
LAN CONFIGURATION
1. Auto Negotiation Enable
2. Max Capability advertised 100baseT Full Duplex
3. Default type 100baseT Full Duplex
ESC. Exit
Current port is the USER PORT
Select item from the menu.
Figure E-22. LAN Configuration Menu
Table E-14. LAN Configuration Parameters
Key Parameter Possible Values Remarks
1 Auto Negotiation
Enable, Disable
Auto Negotiation mode is according to RFC 2239
2 Max Capability
Advertised
10BaseT Half Duplex,
10BaseT Full Duplex,
100BaseT Half Duplex,
100BaseT Full Duplex
Maximum capabilities of the port for the
auto-negotiation process (can be lower then the
actual capabilities)
3 Default Type Port mode: Half Duplex,
Full Duplex
Rate: 10 Mbps, 100 Mbps
This parameter is valid only when the
Auto-negotiation mode is disabled (RFC 2239)
Note
Main Menu
↓
2. Configuration
↓
4. LAN Configuration
Order from: Cutter Networks
Ph:727-398-5252/Fax:[phone]
www.bestdatasource.com