Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 4 Configuration
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Configuring for Operation 4-31
RICi-4E1/T1, RICi-8E1/T1
Configuration > Applications > OAM > End-To-End > Flows > MEP
Flow ID ... (1)
1. Local ID[0 – 8191] ... (0)
2. OAM Destination Address Type (Multicast)
3. Remote ID > (-)
4. MD Level[0 - 7] ... (3)
5. OAM Mode > (Disable)
6. Continuity Verification Mode > (CC Based)
7. OAM Destination MAC Address > (0120D2000103)
8. Default CC Priority > (0)
9. CC Interval > (1 Second)
10. Services
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-33. MEP Menu
Table
4-15. MEP Parameters
Parameter Possible Values Remarks
Flow ID Displays the Flow ID.
Local ID 1 - 8191
Indicates the maintenance entity group’s end point.
Default: Undefined (there is no default value)
OAM Destination
Address Type
Multicast
Unicast
Determines the MAC address sent in OAM messages, which
may be the standard OAM MAC address that was configured
previously in standard mode or the RAD proprietary multicast
address in proprietary mode or a user-defined unicast
address.
Default: Multicast
Remote ID 1 – 8191 The Remote MEP ID is the ID that identifies incoming OAM
messages. Every unit’s ID must be unique, therefore the local
and remote ID must not be identical.
MD Level 0–7 OAM domain level
Default: 3
Note: This parameter is configurable only in standard mode.
OAM Mode Disabled
Initiate
React
Determines the OAM behavior.
Disabled –No CC performed,
Initiate – The unit initiates and responds to OAM messages,
React – The unit responds to OAM messages, but does not
initiate them.
Default: Disabled
Continuity
Verification Mode
LB Based
CC Based
Determines the CC behavior. LB Based is used only for RAD
proprietary.
Default: Disabled
Note: This parameter is available in Initiate/React OAM mode
and RAD Proprietary mode
.