Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-22 Configuring for Operation RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
Binding Bridge Ports
The unit is supplied with the bridge ports pre-bound to the physical interfaces as
listed in
Table 4-10 . Usually there is no need to modify the default bridge
bindings.
Table 4-10. Factory Set Bridge Port Bindings
Bridge Port Bound to
1 Reserved for management host
2 MLPPP
3 Ethernet 1
4 Ethernet 2
5 Ethernet 3
6 Ethernet 4
³ To bind a bridge port:
1. From the Bridge Ports menu, select a bridge port.
2. Select Bind to define a physical port to be bound to the current bridge port.
The Bind menu appears.
Bridge port 1 is permanently bound to the management host.
RICi-4E1/T1, RICi-8E1/T1
Configuration > Application > Bridge > Bridge port > Bind
1. Type (Fast)
2. Fast Ethernet [1-4] …(1)
3. Save
Please select item from 1 to 3
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Figure 4-21. Bridge Ports Bind Menu
3. From the Bind menu, select Type and choose the port type to which the
bridge port should be bound: Fast (Fast Ethernet) or MLPPP.
4. If you selected Fast in the previous step, select Fast Ethernet and type the
number of the Ethernet port (1-4), which you want to bind the bridge port
to.
5. In the Bridge Port Bind menu, select Save.
Press <ESC> to return to the Bridge Ports menu.
6. In the Bridge Port menu, configure the Bridge Port parameters as listed in
Table 4-9 . The settings pertain to the port to which you bound the bridge
port in the previous steps.
7. Select Save.
Note