Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-20 Configuring for Operation RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
RICi-4E1/T1, RICi-8E1/T1
MAC table handling
1. VLAN ID (1)
2. MAC Address … (00-00-00-00-00-00)
3. Receive Bridge Port [1-6] (1)
4. Save
Please select item from 1 to 4
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Figure 4-19. Static MAC Table, Add Mode
3. In Add mode, do the following:
 Select MAC Address, and enter a new MAC address.
 Select VLAN ID, and choose a VLAN ID for the MAC address within the
range of 1–4094.
 Select Receive Bridge Port, and choose the interface this MAC address
should be attached to.
 Select Save to save the MAC address.
4. Press <ESC> to return to the Static MAC Table.
³ To remove a static address from the table:
• In the Static MAC Table menu, select a MAC address that you want to remove
and press <R>.
The MAC address is deleted from the table.
³ To clear the MAC table:
1. In the Static MAC Table menu, press <X>.
The following message appears: Are you sure (Y/N)?
2. Press <Y> to confirm deletion of all MAC addresses from the table.
Configuring the Bridge Ports
The internal bridge parameters, as well as the bridge ports and the VLAN
membership must be configured according to the application requirements.
Available settings and factory-set (default) configuration are listed in
Table 4-10 .
³ To configure a bridge port:
1. Navigate to Main Menu > Configuration > Applications > Bridge > Bridge Port.
2. The Bridge Port menu appears as illustrated in
Figure 4-20 .
3. In the Bridge Port menu, select a bridge port.
4. Configure the bridge port as specified in
Table 4-9 .