Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 4 Configuration
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Configuring for Operation 4-15
RICi-4E1, RICi-8E1
Main menu > Configuration > Physical ports > E1
Port [1 – 8] (1-8)
Frame type > (Unframed)
1. Activation (Up)
2. Transmit clock source (LBT)
3. Line code (HDB3)
4. Line type > (Unbalanced)
5. Rx Sensitivity
6. Save
f – forward
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-14. E1 Port Configuration Menu
Table
4-5. E1 Port Parameters
Parameter Possible Values Remarks
Port number 1–Number of E1 ports
(4 or 8)
The default is 1
Index of E1 ports.
Frame type Unframed Defines frame type.
Activation
Enable/Up (default)
Disable/Down
Sets the administrative status of the E1 port.
Transmit clock
source
Loopback Timing (default)
Internal Clock
System
Transmits the clock source of the E1 port.
Line Code HDB3 (default)
AMI
Indicates the transmission line code.
Line Type Balanced (default)
Unbalanced
Rx Sensitivity -12 db
-43 db (default)
Configuring T1 Interface
³ To configure the T1 ports:
1. Navigate to Main Menu > Configuration > Physical Ports.
The Physical Ports menu appears.
2. From the Physical Ports menu, select T1.
The T1 Port Configuration menu appears as illustrated in
Figure 4-12 .
3. Configure T1 port parameters. Additional information is available in
Table 4-3 .
 To switch to a different port, press <F> and configure the parameters
respectively.