Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-14 Configuring for Operation RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
RICi-4E1/T1, RICi-8E1/T1
Main menu > Configuration > Physical ports > Fast Ethernet >
MAC Access Control
Port ... (1)
Current Number of Protected Addresses ... (0)
1. MAC Protection Administrative Status > (Disable)
2. Maximum Number of Protected MAC Addresses (0)
>
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-13. MAC Access Control Menu
Table
4-4. MAC Access Control Parameters
Parameter Possible Values Remarks
Port number 1–4
The default is 1
Refers to the Fast Ethernet port number. This
parameter is read-only.
Current Number of
Protected Addresses
Shows the current number of learned MAC
Addresses being protected. This parameter is
read-only.
MAC Protection
Administrative Status
Disable
Enable
The default is Disable
Indicates if MAC port protection is disabled or
enabled for the port. If enabled, the port accepts
traffic only from the first MAC address(es) from
which it receives traffic.
Maximum Number of
Protected MAC
Addresses
Specifies the maximum number of source MAC
addresses from which the port is allowed to receive
traffic.
Configuring E1 Interface
³ To configure the E1 ports:
1. Navigate to Main Menu > Configuration > Physical Ports menu > E1
The E1 menu appears as illustrated in
Figure 4-14 .
2. Configure E1 port parameters. Refer to
Table 4-5 for additional information.
Press <F> to change the E1 port number.
3. Select Save.
4. Repeat the above procedure for additional E1 ports in use.