Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 4 Configuration
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Configuring for Operation 4-13
2. Select Fast Ethernet.
The Fast Ethernet menu appears as illustrated in
Figure 4-12 .
3. Configure the Fast Ethernet port parameters. Refer to
Table 4-3 for
additional information.
³ To configure MAC port protection for the Fast Ethernet port:
1. In the Fast Ethernet menu select MAC Access Control.
The MAC Access Control menu appears as illustrated in
Figure 4-13 .
2. Configure the MAC Access Control parameters. Refer to
Table 4-4 for
additional information.
RICi-4E1/T1, RICi-8E1/T1
Main menu > Configuration > Physical ports > Fast Ethernet
Port (1)
1. Activation (Up)
2. Description (ETH 1)
3. Auto Negotiation (Enable)
4. Flow Control (Enable)
5. Max Capability Advertised (100base – TX Full Duplex)
6. MDIX Cross Over (Enable)
7. MAC Access Control >
f – forward
Please select item from 1 to 6
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-12. Fast Ethernet Menu
Table
4-3. Fast Ethernet Parameters
Parameter Possible Values Remarks
Port number 1–4
The default is 1
Refers to the Fast Ethernet port number. This
parameter is read-only.
Activation Up (default)
Down
Activates the Fast Ethernet link.
Auto-negotiation Enable (1) Disable (2) Enables autonegotiation signaling over the Ethernet.
Flow Control Enable (default)
Disable
Configures the default administrative PAUSE mode
for this interface.
Max Capability
Advertised
10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex (default)
Specifies the set of capabilities advertised by the
local auto-negotiation entity.
MDIX Auto Cross
Over
Enable (default)
Disable
Enables and disables Auto Cross Over.