Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-2 Configuring for Management RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
Defining Host IP Parameters
You can manage the unit via a network management station connected to one of
the unit’s ports. In order to establish a proper connection, you have to configure
the host IP address, the subnet mask, the default gateway, and its trap, read and
write communities. In addition, it is possible to create a separate management
VLAN by selecting forwarding mode and VLAN parameters.
³ To define the IP parameters:
1. From the Management menu, select Host IP.
The Host IP menu appears.
RICi-4E1/T1, RICi-8E1/T1
Main Menu > Configuration > System > Management > Host IP
1. IP Address ... (0.0.0.0)
2. IP Mask ... (255.255.255.0)
3. Default gateway ... (0.0.0.0)
4. Read community ... (public)
5. Write community ... (private)
6. Trap community ... (public)
7. Encapsulation >
8. Save
> Please select item from 1 to 8
ESC-Previous menu; !-Main menu; &-Exit; 1 user(s)
Figure 4-1. Host IP Menu
2. In the Host IP menu, do the following:
 Select IP Address, and then enter the IP address of the IP host.
 Select IP Mask, and then enter the host IP subnet mask.
 Select Default Gateway, and then enter the default gateway IP address.
 Select Read Community, and then type the name of a community with
read-only authorization.
 Select Write Community, and then type the name of a community with
write authorization.
 Select Trap Community, and then type the name of a community to which
the unit should send traps.
3. Select Encapsulation to define VLAN tagging performed by the host.
The Encapsulation menu appears.