Specifications

Chapter 3 Operation RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
3-4 Default Settings RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
3.3 Default Settings
Some configuration parameters in RICi-4E1/T1, RICi-8E1/T1 may be set to the
default values. Configuration parameters set to the default values belong to one
of the two following categories:
• Set/configured defaults. These defaults are visible when entering the screen,
for example the terminal bit rate, which is set to 115200 bps when started.
• Not set/configured defaults. These defaults are not visible when entering the
screen and are presented by a blank field. They will show after selecting
‘Save’ in the respective screen. For example, the default for Ingress Filtering
appears once you saved changes in the Bridge Configuration screen.
Configuration parameters without default values assigned require values be
assigned, otherwise you will be unable to save the settings.
Table
3-2 lists the default settings of the RICi-4E1/T1, RICi-8E1/T1 configuration
parameters.
Table 3-2. Default System Settings
Parameter Default Value
Device Name RICi-4E1/RICi-4T1/RICi-8E1/ RICi-8T1
Description Fast Ethernet over Four/Eight E1/T1 NTU
Location Location of the device
Contact Person Name of the contact person
Host IP Address 0.0.0.0
Host IP Mask 255.255.255.0
Host Default Gateway 0.0.0.0
Read Community Public
Write Community Private
Trap Community Public
Host Tagging Untagged
Security Definition All
Telnet/SSH Access Enable
SNMP Access Enable
Web Access Enable
Baud Rate 115.2 kbps