Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-6 Connecting to Management Stations RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
2.9 Connecting to Management Stations
Connecting to an ASCII Terminal
RICi-4E1/T1, RICi-8E1/T1 is connected to an ASCII terminal via a 9-pin D-type
female connector labeled CONTROL. Refer to
Appendix A for the connector
pinout.
³ To connect the ASCII terminal:
1. Connect the male 9-pin D-type connector of the CBL-DB9F-DB9M-STR Control
Port cable to the CONTROL connector.
2. Connect the other end of this cable to an ASCII terminal.
Figure 2-6. Front Panel – Control Port
Terminal cables must have a frame ground connection. Use ungrounded cables
when connecting a supervisory terminal to a DC-powered unit with floating
ground. Using improper terminal cable may result in damage to supervisory
terminal port.
Caution