Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-4 Connecting to Ethernet Equipment RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
³ To remove the SFP module:
1. Disconnect the fiber optic cables from the SFP module.
2. Unlock the wire latch by lowering it downwards (as opposed to locking).
3. Hold the wire latch and pull the SFP module out of the Ethernet port.
2.7 Connecting to Ethernet Equipment
RICi-4E1/T1, RICi-8E1/T1 is connected to the Fast Ethernet equipment via the
fiber optic LC or 8-pin RJ-45 ports. Refer to
Appendix A for the RJ-45 connector
pinout..
³ To connect to Fast Ethernet equipment with fiber optic interface:
• Connect RICi-4E1/T1, RICi-8E1/T1 to the Ethernet equipment using a standard
fiber optic cable terminated with an LC connector.
Figure 2-2. Front Panel - Two 10/100BaseT and two SFP-Based Optical Links
³ To connect to Fast Ethernet equipment with 10/100BaseT interface:
• Connect the LAN to an RJ-45 connector designated 10/100BaseT.
Figure 2-3. Front Panel – Four 10/100BaseT Links