Specifications

RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Site Requirements and Prerequisites 2-1
Chapter 2
Installation and Setup
This chapter includes the following topics:
Site requirements and specifications
Package contents
Required equipment
Installation and setup.
2.1 Introduction
RICi-4E1/T1, RICi-8E1/T1 is shipped ready to use, with factory defaults set. The
device is designed as a desktop units or for mounting in a 19-inch rack. For rack
installation instructions, refer to the
Rack Mounting Kit for 19-inch Racks
guide
that comes with the RM kit.
After installing the unit, use an ASCII terminal connected to the CONTROL port to
perform any configuration necessary. The configuration procedures are described
in
Chapter 3
and
Chapter 4
.
In case of problems, refer to
Chapter 6
.
No internal settings, adjustment, maintenance and repairs should be performed
by either the operator or the user. Such activities must be performed only by
skilled personnel who are aware of the hazards involved.
Always observe standard safety precautions during installation, operation and
maintenance of this product.
2.2 Site Requirements and Prerequisites
AC-powered units should be installed within 1.5 meters (5 feet) of an easily
accessible grounded AC outlet, capable of supplying the required voltage in the
range of 100 to 240 VAC at 50/60 Hz. DC-powered units require 48/60 VDC
(40–72 VDC))
Allow at least 90 cm (36 in) of free space in front of the unit to ensure easy
operator access. For continuous product operation, allow at least 10 cm of free
space at the front and at least 15 cm at the rear of the unit for cable
connections and ventilation. For proper ventilation, keep at least 2.5 cm free
space from the sides and the top of the unit.
The ambient operating temperature is 0
to 50° C (32 to 122°F), at a relative
humidity of up to 90%, non-condensing.
Warning