Specifications

Quick Start Guide RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual

2 Configuring RICi-4E1/T1, RICi-8E1/T1 RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0

2. Configuring RICi-4E1/T1, RICi-8E1/T1

Configure RICi-4E1/T1, RICi-8E1/T1 to the desired operation mode via an ASCII

terminal connected to the front panel CONTROL port. After configuring, you can

manage the unit over Telnet, a PC running a Web browsing application, or SNMP

via either the Ethernet or E1 port.

Remote management requires assigning an IP address.

Starting a Terminal Session for the First Time

For first use, you have to use an ASCII terminal to configure

RICi-4E1/T1, RICi-8E1/T1.

³ To start a terminal session:

1. If not already done, connect a terminal to the CONTROL connector.

2. Turn on the control terminal PC and set its default port parameters to a baud

rate of 115,200 bps, 8 data, 1 stop bit and no parity.

3. Set the terminal emulator to ANSI VT100 emulation (to ensure an optimal

view of system menus).

4. Set the terminal screen width to 132 characters.

5. Enter your user name and password and proceed with the management

session.

The default user name is su, and the default password is 1234.

Configuring the IP Management Parameters

You have to configure the IP address, the subnet mask, and the default gateway.

³ To configure IP management parameters:

• Navigate to the Host IP menu (Main > Configuration > System > Management

> Host IP) and configure the required IP host parameters.

Note