Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 6 Troubleshooting and Diagnostics
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Testing the Unit 6-19
If the target MEP address is all 0s, the Send Link Trace parameter does not
appear in the screen.
2. Define the test parameters according to Table 6-12 .
3. Select Send Link Trace to perform the link trace.
4. Select Results to view the result of the link trace, as illustrated in
Figure 6-21 .
RICi-4E1/T1, RICi-8E1/T1
Main Menu > Diagnostics > OAM Tests > Link Trace
1. Flow ID[1 - 8] ... (1)
Flow Name ... (Put your string here)
2. Destination Type (Target MEP ID)
3. Target MEP ID[1 - 8191] ... (0)
Target MEP Address ... (00-00-00-00-00-00)
4. TTL[1 - 64] ... (64)
5. Send Link Trace
6. Results []
Please select item <1 to 5>
F-Forward; B-Backward
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Figure 6-22. Link Trace Menu – Target MEP ID
Table
6-12. Link Trace Parameters – Target MEP ID
Parameter Possible Values Remarks
Flow ID 1 – 8 The ID of the virtual Ethernet connection.
Flow Name The name of the virtual Ethernet connection you chose.
Note: This parameter is read-only and cannot be configured.
Destination Type Target MAC Address
Target MEP ID
The destination type for the link trace
Default: Target MAC Address
Target MEP ID ID of the remote maintenance endpoint, terminating the
maintenance entity. It must be different from the local MEP ID
and unique for the maintenance domain. If set to 0, no
maintenance end point (MEP) is assigned.
Default: 0
Target MEP
Address
The MAC address of the device assigned as media point at the
target location.
Note: This parameter is read-only . It is automatically updated
by the system when you enter a valid target MEP ID.
TTL 1–64 This is used to limit the number of hops to 64. The first unit to
initiate the trace sets this to 64, then each unit in the trace
decrements it..
Default: 64
Note