Specifications
RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 5 Configuring a Typical Application
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Configuring the Bridge 5-5
Defining Bridge Ports
The unit is supplied with the bridge ports preconfigured for basic use and do not
need to be reconfigured. The factory-set configuration is shown in
Table
5-1
. To
reconfigure the ports, the configuration for each port must first be deleted. Refer
to
Configuring the Bridge Ports
for additional information.
Table
5-1. Default Bridge Port Settings
Bridge Port Configured to
1 Reserved for management host
2 MLPPP bundle
3 Ethernet 1
4 Ethernet 2
5 Ethernet 3
6 Ethernet 4
Defining VLAN Memberships
Define the required VLAN and add to it the relevant bridge ports.
³ To define a VLAN:
1. Navigate to Main > Configuration > Application > Bridge > VLAN Mode.
The VLAN Mode menu appears.
2. Leave the parameters at their default settings (Unaware).
To define and create a new VLAN, refer to
Configuring the Internal Bridge
for
additional information.
3. Add the relevant ports to the defined VLAN (including the Host bridge port if
it is the VLAN used for management).