Specifications

Chapter 5 Configuring a Typical Application RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
5-4 Configuring the Bridge RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
5.3 Configuring E1/T1 Physical Layer
Defines the characteristics of the physical E1 or T1 ports. Set the clock
parameters.
³ To configure the E1/T1 physical layer:
1. Navigate to Main > Configuration > Physical layer > E1/T1.
The E1 or T1 menu appears as appropriate.
2. Leave the parameters unchanged.
Refer to
Configuring Ports at the Physical Level for additional information on
defining the parameters for each T1/E1 physical port.
3. Press <ESC> to return to the Physical Layer menu.
4. Press <ESC> to return to the Configuration menu.
5.4 Configuring the Bridge
This part of the application configuration procedure has four major stages:
• Defining the bridge
• Defining bridge ports and binding them to the relevant physical interfaces
• Defining VLANS and adding them the relevant bridge ports
• Configuring the E1/T1 physical layer.
Defining the Bridge
³ To define the bridge:
1. Navigate to Main > Configuration > Application > Bridge.
The Bridge menu appears.
2. Define the bridge parameters. For additional information on each parameter,
refer to
Configuring the Internal Bridge .