Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 5 Configuring a Typical Application
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Configuring the Management Parameters 5-3
Defining Managers
In this step you define the managers and specify which manager(s) will receive
SNMP traps.
Up to ten managers can be defined. Entering the IP address and corresponding
subnet mask defines each management station. In addition, you can temporarily
prevent a manager station from receiving traps, by masking the network
manager.
³ To access the manager list:
• Navigate to Main > Configuration > System > Management > Manager List
The existing managers appear listed.
³ To define new managers:
1. Press <a>.
A form appears to enter the details for the new manager. An ID is
automatically assigned to the new manager.
2. Specify an IP address for the new manager under Manager IP.
3. In the Trap field, specify Mask or Unmask to mask or unmask traps for the
new management station.
4. Select Save All.
5. Repeat the previous steps for each network manager you wish to add.
³ To update existing manager parameters:
1. In the Manager list, press <Tab> to move the cursor to the Manager IP cell
you wish to modify by pressing.
The selected cell is highlighted and the value is displayed in the “Change
cell” field.
2. Press <1>, and press <Enter> to enter a new IP address for the selected
network manager.
3. Move the cursor to the Trap field and toggle between Mask and Unmask to
mask or unmask traps for the selected management station.
4. Repeat the previous three steps for each manager you wish to update.
5. Press <ESC> to return to the Management menu.