Specifications

Chapter 5 Configuring a Typical Application RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
5-2 Configuring the Management Parameters RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
5.2 Configuring the Management Parameters
This part of the application configuration procedure consists of three major
stages:
Defining the host
Defining the default gateway
Defining managers.
Defining the Host
Defines the host parameters such as IP address and subnet mask, and the
read/write communities.
³ To define the host:
1. Navigate to Main > Configuration > System > Management > Host IP.
The Host IP menu appears.
2. Define the host parameters as follows:
Select Address to define the IP address of the SNMP host.
Select Mask to define the host IP subnet mask.
Select Default Gateway to set the default gateway IP address.
Select Read Community to enter the name of a community with read-only
authorization.
Select Write Community to enter the name of a community with write
authorization.
Select Trap Community to enter the name of a community to which traps
are sent.
3. Press <ESC> to return to the Management menu.
Defining the Default Gateway
Makes the unit available from outside your network.
³ To define the default gateway:
1. Navigate to Main > Configuration > System > Management > Host IP.
The Host IP menu appears.
2. In the Host IP menu, select Default Gateway.
3. Enter the IP address of the default gateway server or specify an IP address of
0.0.0.0 to disable the default gateway.