Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-36 Additional Tasks RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
Configuration>System>Syslog
1. Device Logging Status > (Disable)
2. Device UDP port [1 – 65535] > (514)
3. Facility > (Local 1)
4. Severity level > (Minor)
5. Server Parameters >
>
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-37. Syslog Menu
Table
4-19. Syslog Parameters
Parameter Values Remarks
Device Logging
Status
Disable (default)
Enable
Specifies whether transmitting
syslog messages is enabled or
disabled
Device UDP Port 1–65535 UDP Port used by RICi-4E1/T1,
RICi-8E1/T1 to transmit the
Syslog messages
Facility Local 1 (default) -
Local 7
The software module, task, or
function from which the Syslog
messages are sent
Severity Level Critical – corresponds to the
Emergency (0) severity level of Syslog
Major– corresponds to the Alert (1) and
Critical (2) severity levels of Syslog
Minor (default) – corresponds to the
Error (3) severity level of Syslog
Warning – corresponds to the Warning (4)
severity level of Syslog
Event– corresponds to the Notice (5)
severity level of Syslog
Info– corresponds to the Informational (6)
severity level of Syslog
Debug – corresponds to the Debug (7)
severity level of Syslog
The log messages with severity
levels that equal or exceed the
selected severity level are
transmitted
³ To configure Syslog server parameters:
1. Navigate to the Syslog Server Parameters menu (Configuration > System >
Syslog > Server Parameters).
The Syslog Server Parameters menu appears.
2. Configure the parameters as described in
Table 4-20 .