Specifications

RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual Chapter 4 Configuration
RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0 Additional Tasks 4-35
The Date and Time menu appears.
RICi-4E1/T1, RICi-8E1/T1
Configuration > System > Date and Time
Date (01-10-1949)
Time (00:00:01)
1. NTP Mode (Unicast Client)
2. GMT (0)
3. NTP Server IP Address (172.17.163.93)
4. NTP Update Interval (sec) (5)
5. Send Initiated NTP Request
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-36. Date and Time Screen
Table
4-18. NTP Client Parameters
Parameter Possible Value Remarks
NTP Mode Unicast Client
Disable (Default)
NTP request sent to a specific IP address
GMT -12 – 12
The default is 0
Offset from Greenwich Main Time
NTP Server IP
Address
The default is 0.0.0.0 The NTP server’s IP address.
NTP Update
Interval (sec)
0 (disable), default
1 - 4294967295
The time in seconds between NTP update requests.
Send Initiated
NTP Request
Click to submit an NTP update request. Initiated update
requests do not affect the specified update interval.
Configuring the Syslog Parameters
Syslog enables you to forward log messages via UDP over the network to up to
five Syslog servers. To allow logging/sharing of system events to the Syslog
servers, you need to configure the Syslog and Syslog server(s) parameters.
³ To configure the Syslog parameters:
1. Navigate to the Syslog menu (Configuration > System > Syslog).
The Syslog menu appears.
2. Configure the parameters as described in
Table 4-19 .