Specifications

Chapter 4 Configuration RICi-4E1/T1, RICi-8E1/T1 Installation and Operation Manual
4-32 Configuring for Operation RICi-4E1/T1, RICi-8E1/T1 Ver. 2.0
Parameter Possible Values Remarks
OAM Destination
MAC Address
MAC Address Determines the MAC address sent in OAM messages,
configurable only for Unicast MAC Address.
Default: 000000000000 in Unicast, 0120D2000100 + MD
Level in Multicast RAD Proprietary, Standard OAM MAC
Address + MD Level in Multicast Standard
CC Interval 100ms
1 sec
10 sec
1 min
10 min
Sets the CC interval between messages.
Default: 1 sec
Note: This parameter is configurable only in standard mode.
Default CC
Priority
The priority CFM message is sent if no service is defined for
the flow. If a service is defined, the CC is performed at the
highest priority service for the flow.
Services Refer to Figure 4-34 and Table 4-16
Note: This parameter is available only in proprietary mode.
³ To configure the flow services:
1. From the MEP menu (Configuration > Applications > OAM > End-To-End >
Flows > MEP), select Services.
The Services menu appears.
2. Configure the parameters as specified in
Table 4-16 .
3. Save your changes.
RICi-4E1/T1, RICi-8E1/T1
Configuration > Applications > OAM > End-To-End > Flows > MEP >
Services
Service ... (1)
1. Performance Monitoring ... (Enabled)
2. Priority ... (0)
3. Delay Objective (msec) ... (0)
4. Delay Variation Objective (msec) ... (0)
Event Reporting
5. Frame Loss Ratio >
6. Frames Above Delay >
7. Frames Above Delay Variation >
8. Unavailability Ratio >
F-Forward;
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-34. Service Menu