Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-6 Installation in 19" Racks SPS-6, SPS-12
2.5 Installation in 19" Racks
SPS-6, SPS-12 can be installed in a 19" rack. Unit height corresponds to 1U
(1.75"). The width of the unit is slightly less than the available mounting width.
An adapter kit provides the hardware necessary for installation of the SPS-6/SPS-12
in a 19" rack. The paragraph below provides step-by-step instructions for this
procedure.
Disconnect the units from AC power while performing the following
procedures.
Installing the Unit
The rack adapter kit for the installation includes two short brackets. The brackets
are fastened by means of screws to the two side walls of the case. The installation
of the SPS-6 is shown in
Figure 2-4; the installation of the SPS-12 is similar.

To install the unit:
1. Attach the two brackets to the side walls of the unit. Each bracket is fastened
by two screws (with flat washers), which are inserted into the two front holes
on the side wall (nuts are already in place, on the inner side of the wall).
After attaching the brackets, the unit is ready for installation in the 19" rack.
2. Fasten the brackets to the side rails of the 19" rack using four screws (not
included in the kit), two on each side.
Warning