Specifications

Chapter 4 Configuration Installation and Operation Manual
4-36 Configuring RICi-622GE for Operation RICi-622GE Ver. 1.0
Parameter Description Values
Flow Key Determines which field is used by the
classifier for the flow mapping.
This parameter is present only if flow
classification mode is flow-based.
SP-VLAN ID – Ingress frames are classified
according to their Service Provider (SP)
VLAN ID
SP-VLAN and 802.1p – Ingress frames are
classified according to their Service
Provider (SP) VLAN ID and P-bit values
CE-VLAN ID – Ingress frames are classified
according to their Customer Edge (CE)
VLAN ID
CE-802.1p – Ingress frames are classified
according to their Customer Edge (CE)
VLAN P-bit value
Note: SP-VLAN ID/SP-VLAN and 802.1p parameters are relevant for only the network ports. CE-VLAN ID and
CE-802.1p parameters are relevant for only the user ports.
CoS Profile Binds the current port to a valid Class of
Service profile
A valid CoS profile
Default VID Specifies a default VLAN ID to be assigned
to incoming frames that have no VLAN tags.
This parameter is relevant when the flow
key is set to SP-VLAN, SP-VLAN and 802.1p,
or CE-VLAN ID.
1–4094
Default 802.1p Specifies a default 802.1p value to be
assigned to the incoming frames that have
no VLAN tags. This parameter is relevant
when the flow key is set to SP-VLAN and
802.1p or CE-802.1p.
It is also used for the CoS mapping, when
the Ingress Priority Method is 802.1p and a
frame arrives without a VLAN tag.
0–7
SP Tag Protocol
Identifier
Determines the tag protocol identifier. 0–FFFF
Ingress MTU Defines the maximum transmission unit
(MTU) for ingress frames. Frames above this
size are discarded.
64–2048 (Fast Ethernet traffic)
64–9600 (Gigabit Ethernet traffic)
Loop detection Defines whether loop detection is
performed
Enable
Disable
This parameter is not available if LAG is
enabled.
Note: Loop detection frames are sent
with the host VLAN ID.
Marking Profile Binds the current port to a valid marking
profile
A valid marking profile