Specifications

Chapter 4 Configuration Installation and Operation Manual
4-34 Configuring RICi-622GE for Operation RICi-622GE Ver. 1.0
RICi-622GE
Configuration>Application>Bridge>Bridge Port
Bridge Port > (ETH-1)
1. Usage > (User)
2. Accept frame type (All)
3. Flow Classification Mode (Flow-based)
4. Flow Key > (CE-VLAN ID)
5. CoS Profile > (DefaultCosPBits1)
6. Default VID [1-4094] ... (1)
7. Default 802.1p [0-7] ... (0)
8. Ingress MTU [64-9600] ... (2048)
9. L2CP Handling >
10. Egress Bandwidth profile >
11. Loop detection (Disable)
>
F - Forward ;
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-41. Bridge User Port Configuration Menu, LAG Disabled
RICi-622GE
Configuration>Application>Bridge>Bridge Port
Bridge Port > (LAG-1)
1. Usage > (User)
2. Accept frame type (All)
3. Flow Classification Mode (Flow-based)
4. Flow Key > (CE-VLAN ID)
5. CoS Profile > (DefaultCosPBits1)
6. Default VID [1-4094] ... (1)
7. Default 802.1p [0-7] ... (0)
8. Ingress MTU [64-9600] ... (2048)
9. L2CP Handling >
10. Egress Bandwidth profile >
>
F - Forward ;
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-42. Bridge User Port Configuration Menu, LAG Enabled
³ To configure the network bridge ports:
1. From the Bridge Port menu, select Forward to advance to bridge ports VCG -1
through VCG-<n>, where n = 1–8, depending on how many active VCGs are
defined.
2. From the Bridge Port menu, configure the parameters as detailed in
Table 4-10 .