Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Operation 4-33
Parameter Description Values
GFP Opens GFP submenu
This parameter is visible only if GFP is
enabled for the VCG
Table 4-9. VCG GFP Parameters
Parameter Description Values
FCS
Defines whether to calculate frame
checksum
Yes – Calculate the frame checksum
No – Do not calculate the frame
checksum
Payload Scrambling
Defines whether to perform payload
scrambling
Yes – Perform payload scrambling
No – Do not perform payload scrambling
Configuring RICi-622GE at the Application Level
At the application level you can configure the following operation entities:
• Bridge port parameters
• Quality of Service (QoS)
• Flows.
If LAG is enabled for the Gigabit Ethernet ports, they are treated as one unit in
the bridge port and flow menus, i.e. instead of screens for ports ETH-1 and
ETH-2, there is one screen with LAG-1.
Configuring the Bridge Ports
RICi-622GE supports filtering of incoming traffic, accepting all frames or only
those that have VLAN tags. The incoming frames can be assigned default VID and
priority. The user traffic is mapped into separate flows using the configurable
flow classification keys, and manipulated according to the defined marking and
bandwidth profiles. In addition, for each port you can configure the ingress and
MTU size.
³ To configure the bridge (user) port:
1. From the Bridge menu (Configuration > Application > Bridge), select
Bridge Port.
The Bridge Port menu for the first Gigabit Ethernet port appears. Select
Forward to advance to the second port if desired.
If LAG is enabled, the Bridge Port menu appears with LAG-1 rather than with
ETH-1 and ETH-2.
2. From the Bridge Port menu, configure the parameters as detailed in
Table 4-10 .
Note