Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Operation 4-31
When you activate a VCG with VCs that have not been mapped, you receive a
warning message when you update the database. After you set up mapping for
the VCs in the VCGs, this message does not appear.
³ To modify a VCG:
1. Navigate to the VCG menu (Configuration > Logical Layer > VCAT).
2. Navigate to the VC that you wish to modify, by clicking f.
3. Configure the VCG parameters as detailed in
Table 4-8.
³ To modify the GFP parameters of a VCG:
1. From the VCG menu, select GFP to navigate to the GFP menu.
2. Configure the VCG GFP parameters as detailed in
Table 4-8.
RICi-622GE
Configuration>Logical Layer>VCAT
1. VCG (VCG-8)
2. Administrative Status (Up)
3. VC Type (VC-4)
4. LCAS (Yes)
4. Number of VCs [1 – 8] (3)
5. Encapsulation (GFP)
6. VCAT (No)
7. Minimum Number of VCs (2)
8. VCG Name … (VCG 8)
9. GFP >
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-39. VCG Menu
The VCG parameters shown in the menu differ according to the methods and
protocols selected.
Note
Note