Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Operation 4-29
2. In Add mode, add the desired Failed Interface and Affected Interface.
Affected Interface specifies the VCG or Ethernet interface to shut down upon
failure of the corresponding Failed Interface (Ethernet or VCG).
RICi-622GE
Configuration>System>Fault Propagation
Failed Interface Affected Interface
Eth 1 VCG
Eth 2 VCG
VCG Eth 2
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-35. Fault Propagation Menu
Configuring the Logical Layer
The following parameters can be configured for the VCGs at the logical level:
• Administrative Status
• VC type and number
• LCAS
• Encapsulation
• VCAT.
The default logical layer configuration for RICi-622GE is one VCG containing four
VCs of type VC-4 (SDH) or STS-3c (SONET), as shown in the following figures.
RICi-622GE
Configuration>Logical Layer>VCAT
1. VCG (VCG-1)
2. Administrative Status (Up)
3. VC Type (VC-4)
4. Number of VCs [1 – 8] (4)
5. Encapsulation (GFP)
6. VCAT (Yes)
7. VCG Name (Put your string here)
8. GFP >
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-36. VCG Menu Default Configuration, SDH