Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Operation 4-19
RICi-622GE
Configuration>Physical layer>LAG
1. LAG Enable > (Disable)
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-22. LAG Menu, LAG Disabled
RICi-622GE
Configuration>Physical layer>LAG
LAG Is Active On ETH1-ETH2!
1. LAG Enable > (Enable)
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-23. LAG Menu, LAG Enabled
Configuring SDH/SONET Interface
Frame type, transmit clock source, VCG mapping, Automatic Protection Switching
(APS), interface parameters, and HVC parameters can be configured for the
SDH/SONET ports at the physical level.
Configuring SDH/SONET Port Parameters
³ To configure SDH/SONET frame type:
1. From the SDH/SONET menu (Configuration > Physical Layer > SONET/SDH),
select Frame type to specify the frame type (SDH or SONET).
A confirmation message appears.
Are you sure you want to reset device (Y/N)?
2. Type Y to confirm or N to cancel.
If you type Y, the frame type is set to the specified value, and the unit
resets.