Specifications

Chapter 4 Configuration Installation and Operation Manual
4-18 Configuring RICi-622GE for Operation RICi-622GE Ver. 1.0
Parameter Description Values
Speed and Duplex Defines the speed and duplex mode for
autonegotiation. This is configurable for
only RJ-45 copper interface ports, when
autonegotiation is disabled.
10BaseT Half Duplex
10baseT Full Duplex
100baseT Half Duplex
100baseT Full Duplex
1000base T Full Duplex
Configuring Ethernet Redundancy
You can enable redundancy for the Gigabit Ethernet ports, so that one port is
active and the other is standby, by configuring LAG (link aggregation) for the
Ethernet ports.
³ To configure the Gigabit Ethernet link aggregation:
1. From the Physical Layer menu (Configuration > Physical Layer), select LAG.
The LAG menu appears, indicating the Link Aggregation status (enabled or
disabled).
2. From the LAG menu, select LAG Enable and set it to Enable or Disable.
3. Type % to update the database with your change.
A confirmation message appears.
Are you sure you want to update configuration? (Y/N)
4. Type Y to confirm.
The change to the link aggregation status is applied.
When LAG is enabled, the two Gigabit Ethernet ports are treated as one unit in
the bridge port and flow menus, i.e. instead of screens for ports ETH-1 and
ETH-2, there is one screen with LAG-1.
RICi-622GE
Configuration>Physical layer
1. SONET/SDH >
2. Ethernet >
3. LAG >
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-21. Physical Layer Menu