Specifications

Chapter 4 Configuration Installation and Operation Manual
4-16 Configuring RICi-622GE for Operation RICi-622GE Ver. 1.0
RICi-622GE
Configuration>System>Control Port > Terminal
1. Security Timeout (min) [1 – 60] > (10)
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-18. Terminal Menu
4.2 Configuring RICi-622GE for Operation
The recommended configuration procedure for RICi-622GE includes the following
stages:
1. Configuring Ethernet and SDH/SONET interfaces at the physical level
2. Configuring Fault Propagation
3. Configuring VCGs at the logical level
4. Configuring RICi-622GE at the application level:
 Configuring bridge port parameters
 Configuring QoS parameters
 Configuring Ethernet flows.
Setting Physical Layer Parameters
RICi-622GE includes two STM-4/OC-12 ports (optionally redundant), two Gigabit
Ethernet user ports (optionally redundant), and a Fast Ethernet management
port. The Fast Ethernet management port is not user-configurable. It is
automatically configured by the system for autonegotiation and full duplex mode.
Configuring Ethernet Interface
The following parameters can be configured for the Gigabit Ethernet ports at the
physical level:
• Administrative status
• Autonegotiation
• Maximum advertised capability for autonegotiation procedure
• Data rate and duplex mode, when autonegotiation is disabled
• Ethernet link aggregation.