Specifications
Chapter 4 Configuration Installation and Operation Manual
4-14 Configuring RICi-622GE for Management RICi-622GE Ver. 1.0
Not Connected – Selected server is a backup RADIUS server
Disconnected – Connection to the selected server has timed out.
2. Configure the following parameters:
Server Access – Disables or enables the RADIUS server
Server IP Address – IP address of the RADIUS server.
Key String – The shared secret is a password used by RADIUS to
authenticate the client. RICi-622GE encrypts the user-password, if present;
using the secret it shares with the RADIUS server. Any alphanumeric string
up to 16 characters is permitted.
Number of retries – The number of retries to be made when sending
request to the RADIUS server): Permitted values are 0–5.
Timeout – The maximum time RICi-622GE waits for a single request
response from the RADIUS server (in seconds). After this time the request
is retransmitted.): Permitted values are 0–60.
Authentication Port – The UDP port number to be used for the RADIUS
authentication application. You must define the same value in the RADIUS
server.): any valid UDP port number.
RICi-622GE
Configuration>System>Management>Management Access>Radius Parameters
Server Sequence Number (1)
Server Status (Not connected)
1. Server access (Enable)
2. Server IP address (172.17.150.71)
3. Key String (******)
4. Number of Retries [0-10] (3)
5. Timeout (in seconds) [1-5] (2)
6. Authentication Port [1-65535] (1812)
>
ESC-prev.menu; !-main menu; &-exit 1 M/2 C
Figure
4-16. Radius Parameters Menu
³ To configure RADIUS operation mode:
• From the Management Access menu (Configuration > System > Management
> Management Access), select RADIUS Authentication and select one of the
authentication modes:
Disable – RADIUS authentication is disabled
Enable Remote – RICi-622GE uses authentication database stored at the
RADIUS server to check if the entered user name and password match the
data server records. User authentication fails if one the following occurs:
No user name record is found
Password does not match user name
Connection to the RADIUS server is lost.