Specifications

Chapter 4 Configuration Installation and Operation Manual
4-12 Configuring RICi-622GE for Management RICi-622GE Ver. 1.0
Configuring Target Address
Each target must have a valid IP address. Also, a previously configured parameter
set and notification tags must be assigned to the target.
³ To configure the target address:
1. From the Target Address menu (Configuration > System > Management >
SNMPv3 Settings > Targets and Notify > Target Address), do the following:
 Select Name and enter an ASCII string identifying the target
 Select IP Address and enter valid IP address of the NMS. The IP address
must be in xxx.xxx.xxx.xxx:162 format, where 162 is a standard SNMP port
used for sending traps.
 Select Params Name and enter name of the previously defined target
parameter set to be assigned to this target
 Select Tag List and enter list of previously defined notification tags.
2. To view the summary of the SNMPv3 target configuration, select Summary
Target Table from the SNMPv3 Settings menu (Configuration > System >
Management > SNMPv3 Settings).
RICi-622GE
Configuration>System>Management>SNMPv3 Settings>Targets and Notify>Target Address
1. Name ... ()
2. IP Address ... ()
3. Params Name ... ()
4. Tag List ... ()
>
ESC-prev.menu; !-main menu; &-exit 1 M/2 C
Figure 4-14. Target Address Menu
Mapping SNMPv1 to SNMPv3
RICi-622GE supports coexistence of different SNMP versions by mapping
SNMPv1/SNMPv2 community name to the SNMPv3 security name value. The
mapping is performed according to the requirements in RFC 3587.
³ To map SNMPv1 to SNMPv3:
• From the SNMPv1/v3 Mapping menu (Configuration > System > Management
> SNMPv3 Settings > SNMPv1/v3 Mapping), do the following:
 Select Community Index and enter SNMP community index
 Select Community String and enter SNMPv1/SNMPv2 community name
 Select Security Name and enter SNMPv3 security name mapped to the
SNMPv1/SNMPv2 community name
 Select Transport Tag and enter a set of transport endpoints that are used
in two ways: