Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Management 4-11
³ To configure target parameters:
• From the Target Params menu (Configuration > System > Management >
SNMPv3 Settings > Targets and Notify > Target Params), do the following:
 Select Name and enter an ASCII string identifying the current set of target
parameters
 Select Message Processing Model and enter the Message Processing Model
to be used when generating SNMP messages using this entry:
 SNMPv1
 SNMPv2c
 SNMPv2u
 SNMPv3.
 Select Security Model and enter the Security Model to be used when
generating SNMP messages using this entry:
 Any
 SNMPv1
 SNMPv2c
 User-Based Security Model (USM).
 Select Security Name and enter identification of the principal on whose
behalf SNMP messages are to be generated using this entry. This can be
either SNMPv3 user or SNMPv1/SNMPv2 community string.
 Select Security Level and enter the level of security to be used when
generating SNMP messages using this entry:
 noAuthNoPriv – Authorization and privacy are disabled
 authNoPriv – Authorization is enabled, privacy is disabled)
 authPriv – Authorization and privacy are enabled.
RICi-622GE
Configuration>System>Management> SNMPv3 Settings> Targets and Notify > Target
Params
1. Name ... ()
2. Message Processing Model > ()
3. Security Model > ()
4. Security Name ... ()
5. Security Level > ()
>
ESC-prev.menu; !-main menu; &-exit 1 M/2 C
Figure 4-13. Target Params Menu