Specifications

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring RICi-622GE for Management RICi-622GE Ver. 1.0
2. Type S to save your changes.
A confirmation message appears.
CURRENT CONFIGURATION OF SNMP AGENT WILL BE DELETED! CONTINUE? (Y/N)
3. Type Y to confirm or N to cancel.
If you type Y, SNMPv3 is enabled and the SNMPv3 Settings line appears in
the Management menu.
³ To configure SNMPv3:
1. From the Management menu (Configuration > System > Management), select
SNMPv3 Settings.
The SNMPv3 Settings menu appears (see
Figure 4-9 ).
The SNMPv3 Settings menu includes the following information:
 Engine Boots (The number of times that the SNMP engine has reinitialized
since its identification was last configured.)
 Engine Time (The number of seconds since the last SNMP engine boot)
 SNMP Message Size (The maximum length of an SNMP message (in octets)
that the SNMP engine can send or receive and process.)
RICi-622GE
Configuration>System>Management>SNMPv3 Settings
Engine Boots (4)
Engine Time (10044)
SNMP Message Size ... (1500)
1. Users >
2. Targets & Notify >
3. SNMPv1/v3 Mapping >
4. SNMPv3 Factory Defaults
5. Summary User Table []
6. Summary Target Table []
>
ESC-prev.menu; !-main menu; &-exit 1 M/2 C
Figure 4-9. SNMPv3 Settings Menu
Adding SNMPv3 Users
³ To add an SNMPv3 user:
1. From the SNMPv3 Users menu (Configuration > System > Management >
SNMPv3 Settings > Users), perform the following:
 Select Security Name and enter security name for a new user (up to 32
alphanumeric characters).