Specifications

Installation and Operation Manual Chapter 4 Configuration
RICi-622GE Ver. 1.0 Configuring RICi-622GE for Management 4-7
 Unmasked – All alarms are enabled. The manager is informed of the
occurrence of any alarm (entry or exit to/from alarm state).
RICi-622GE
Configuration>System>Management>Manager list
Num IP address Trap
1 198.25.6.2 (Unmasked)
2 0.0.0.0 (Unmasked)
3 0.0.0.0 (Unmasked)
4 0.0.0.0 (Unmasked)
5 0.0.0.0 (Unmasked)
6 0.0.0.0 (Unmasked)
7 0.0.0.0 (Unmasked)
8 0.0.0.0 (Unmasked)
9 0.0.0.0 (Unmasked)
10 0.0.0.0 (Unmasked)
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 4-8. Manager List Menu
Configuring SNMPv3
RICi-622GE supports the SNMP version 3 entity, providing secure access to the
device by authenticating and encrypting packets transmitted over the network.
When SNMPv3 is disabled, RICi-622GE supports SNMPv1.
Follow these steps to configure the SNMPv3 entity:
1. Enable SNMPv3.
2. Add a new user.
3. Add a new notification entry.
4. Assign traps to notification entries.
5. Configure target (NMS) parameters.
6. Specify the target address, define its parameter set, and assign notification
tags.
7. Map SNMPv3 settings to SNMPv1 settings (if necessary).
Enabling SNMPv3
The SNMPv3 entity is enabled from the Management menu.
³ To enable SNMPv3:
1. From the Management menu (Configuration > System > Management), select
SNMPv3 and enable the SNMPv3 entity.