Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring RICi-622GE for Management RICi-622GE Ver. 1.0
The User Access menu is displayed (see Figure 4-7 ).
3. From the User Access menu, do the following:
 Select User name, and enter a name for a new user.
 Select Permission, and specify the user’s access rights (full control or read
only).
 Select Access, and specify the user’s access methods (Terminal,
Telnet/SSH, Web, Telnet and Web, or all of them).
 Select ‘su’ password, and enter your current superuser password.
 Select New password, and assign a password to a new user name.
 Select Confirm and re-enter the new user password to confirm it.
³ To delete an existing user:
• From the User Access menu, do the following:
 Type F to display a user that you intend to delete.
 Select ‘su’ password, and enter your current superuser password.
Type D to delete the current user.
RICi-622GE
Configuration>System>Management>Management Access>User Access
1. User name ... (su)
2. Permission > (Full Control)
3. Access > (All)
4. ‘su’ password ... ()
5. New password ... ()
6. Confirm New Password ... ()
>
Please select item <1 to 6>
ESC-prev.menu; !-main menu; &-exit 1 M/2 C
Figure 4-7. User Access Menu
Configuring Network Managers
You can configure up to 10 network managers to which the RICi-622GE SNMP
agent sends traps. In addition, you can temporarily prevent a manager station
from receiving traps by masking the network manager.
³ To configure network managers:
• From the Manager List menu (Configuration > System > Management >
Manager List), do the following in the manager list table entry:
 Select IP address and enter the IP address
 Select Trap and configure to the appropriate value:
 Masked –All alarm traps are masked