Specifications

Chapter 4 Configuration Installation and Operation Manual

4-2 Configuring RICi-622GE for Management RICi-622GE Ver. 1.0

³ To define the host IP parameters:

• From the Host menu (Configuration > System > Management> Host), perform

the following:

 Select IP Address to define the host IP address

 Select IP Mask to define the host IP mask

 Select Default Gateway to enter the default gateway IP address.

The default gateway must be in the same subnet as the host.

If SNMPv3 is not enabled, then in order to establish a proper SNMP management

link, you must specify the read community, write community, and trap

community. These community parameters are in the menu only if SNMPv3 is not

enabled.

³ To configure RICi-622GE communities:

• From the Host menu (Configuration > System > Management> Host), do the

following:

 Select Read community to enter the name of a community with read-only

authorization (up to 20 alphanumeric characters, case sensitive).

 Select Write community to enter the name of a community with write

authorization (up to 20 alphanumeric characters, case sensitive).

 Select Trap community to enter the name of a community to which

RICi-622GE sends traps (up to 20 alphanumeric characters, case sensitive).

You must assign different names to the Read and Write communities.

RICi-622GE

Configuration>System>Management>Host

1. IP address ... (0.0.0.0)

2. IP mask ... (0.0.0.0)

3. Default Gateway ... (0.0.0.0)

4. Read community ... (public)

5. Write community ... (private)

6. Trap community ... (public)

7. Encapsulation >

ESC-prev. menu; !-main menu; &-exit 1 M/2 C

Figure

4-1. Host Menu, SNMPv3 not enabled

Note