Specifications

RICi-622GE Ver. 1.0 Configuring RICi-622GE for Management 4-1
Chapter 4
Configuration
This chapter illustrates the configuration RICi-622GE screens and explains their
parameters. The menu tree of the RICi-622GE management software is shown in
Chapter 3 .
For your convenience, parameters that are mandatory for configuration, such as
RICi-622GE host IP settings, are located in the Quick Setup menu (Main menu >
Configuration > Quick Setup). This menu is explained in the Quick Start Guide at
the beginning of the manual, and the menu parameters are explained in the
relevant sections of this chapter.
4.1 Configuring RICi-622GE for Management
Usually, initial configuration of the management parameters is performed via
ASCII terminal. Once the RICi-622GE host IP parameters are set, it is possible to
access it via Telnet, ConfiguRAD, or SNMP-based management system for
operation configuration.
Perform the following steps to configure RICi-622GE for management:
•
Defining Host IP Parameters
• Entering Device Information
• Configuring Host Encapsulation
• Controlling Management Access
• Configuring User Access
• Configuring Network Managers
• Configuring SNMPv3
• Configuring RADIUS Client
• Configuring Control Port Parameters .
Defining Host IP Parameters
RICi-622GE can be managed by a network management station that is located on
the LAN connected to the unit’s network or first user port, or out-of-band Fast
Ethernet management port. In order to establish a proper connection, it is
necessary to define the host IP address, subnet mask, and default gateway.