Specifications

Chapter 3 Operation Installation and Operation Manual
3-2 Default Settings RICi-622GE Ver. 1.0
Figure 3-2. RICi-622GE Back Panel
Table
3-1. RICi-622GE LEDs
Name LED Color Function
POWER Green On: RICi-622GE is powered on
Off: RICi-622GE is off
RDY Green On: RICi-622GE has completed its startup and is ready for operation
Off: RICi-622GE has not completed its startup or RICi-622GE is off
TST Yellow On: Test is running such as loopback
Off: No test is running
MAJOR ALM Red On: Major alarm condition is present
Off: No major alarm condition is present
MINOR ALM Red On: Minor alarm condition is present
Off: No minor alarm condition is present
GbE LINK 1,2 Green On: Corresponding Ethernet link is connected
Off: Corresponding Ethernet link is disconnected
GbE ACT 1,2 Yellow Blinking: Ethernet frame received or sent on corresponding link within the
last second
Off: No frame received or sent on corresponding link within the last second
MNG LINK Green On: Ethernet link is connected
Off: Ethernet link is disconnected
MNG ACT Yellow Blinking: Ethernet frame received or sent within the last second
Off: No frame received or sent within the last second
SDH/SONET
ON LINE 1,2
Green On: Corresponding STM-4/OC-12 link is connected
Blinking: Corresponding STM-4/OC-12 link is in standby status
Off: Corresponding STM-4/OC-12 link is not connected
SDH/SONET
LOS 1,2
Red On: Loss of signal on corresponding STM-4/OC-12 link
3.3 Default Settings
Table 3-2 lists the default settings of the RICi-622GE configuration parameters.
Table 3-2. RICi-622GE Default Settings
Type Parameter Default Value
System
Host IP Address 0.0.0.0