Specifications

RICi-622GE Ver. 1.0 Site Requirements and Prerequisites 2-1

Chapter 2

Installation and Setup

This chapter describes installation and setup procedures for the RICi-622GE unit.

After installing the unit, refer to

Chapter 3

for operating instructions.

If a problem is encountered, refer to

Chapter 6

for test and diagnostic

instructions.

Internal settings, adjustment, maintenance, or repairs must be performed only by

a skilled technician who is aware of the hazards involved.

Always observe standard safety precautions during installation, operation, and

maintenance of this product.

For your protection and to prevent possible damage if a fault condition such as a

lightning strike or contact with high voltage power lines occurs on the cables

connected to the equipment, RICi-622GE must be properly grounded at all times.

Any interruption of the protective (grounding) connection inside or outside the

equipment, or disconnection of the protective ground terminal, can make this

equipment dangerous. Intentional interruption is prohibited.

2.1 Site Requirements and Prerequisites

RICi-622GE is intended for installation as a desktop unit, mounted on the wall, or

mounted in a 19-inch rack or 23-inch rack. The following mounting kits are

available from RAD:

• RM-34 for mounting one 19-inch RICi-622GE unit in a 19-inch rack

• RM-34-23 for mounting one 23-inch RICi-622GE unit in a 23-inch rack

• WM-34 for mounting one 19-inch RICi-622GE unit on the wall.

AC-powered RICi-622GE units should be installed within 1.5 meters (5 feet) of an

easily accessible grounded AC outlet capable of furnishing the required supply

voltage, in the range of 100 to 240 VAC, 50/60 Hz.

DC-powered RICi-622GE units require a -48 VDC power source, which must be

adequately isolated from the main supply.

Refer also to the sections describing connections of AC and DC mains at the

beginning of the manual.

Allow at least 90 cm (36 in) of frontal clearance for operator access. For

continuous product operation allow at least 10 cm of frontal clearance and at

Warning

Note

Warning