Specifications

RICi-622GE Ver. 1.0 Configuring RICi-622GE 1
Quick Start Guide
Installation of RICi-622GE should be carried out only by an experienced
technician. If you are familiar with RICi-622GE, use this guide to prepare the units
for operation.
1. Installing RICi-622GE
Connecting the Interfaces
1. Connect the SDH/SONET equipment to the fiber optic front panel connectors.
2. Connect the 1000BaseT or 1000BaseSx/Lx / 100BaseSx/Lx LAN to the ETH
front panel connectors.
3. Use a cross cable to connect the control terminal to the front panel CONTROL
connector.
or
Connect a Telnet host, a PC running a Web browsing application, or an SNMP
management station to the ETH MNG port.
Connecting the Power
Connect the power cable to the power connector on the RICi-622GE.
The unit has no power switch. Operation starts when power is applied to the
power connector.
2. Configuring RICi-622GE
Configure RICi-622GE to the desired operation mode via an ASCII terminal connected
to the front panel CONTROL port. Alternatively, you can manage RICi-622GE over
Telnet, a PC running a Web browsing application, or an SNMP-based management
system.
Starting a Terminal Session for the First Time
³ To start a terminal configuration session:
1. Connect an ASCII terminal to RICi-622GE CONTROL port (default settings are:
115,200; N; 8; 1; Flow control: None).
2. Set the terminal emulator to VT100 emulation for optimal view of system
menus.
3. If you are using HyperTerminal, set the terminal mode to 132-column mode
for optimal view of system menus (Properties>Settings>Terminal Setup
>132 column mode).