Specifications

Installation and Operation Manual Appendix B Boot Sequence and Downloading Software
RICi-622GE Ver. 1.0 Transferring Software Files B-3
The Boot Manager menu appears (see Figure B-1 ).
3. From the Boot Manager menu, select Download Files or an Application by
XMODEM.
RICi-622GE displays the following message:
Select Copy number for download ( 0 )
4. Select the backup partition by typing its number, 0 or 1.
RICi-622GE responds with the following string:
Please start the XMODEM download.
5. Send the software release file to RICi-622GE using the XMODEM utility of you
terminal application.
Once the downloading is completed, RICi-622GE saves the new release as an
active partition, the former active partition turns into backup, and the boot
sequence continues normally.
If a failure occurs during the download, the partially downloaded software is
erased. In this case, only active software is left in the flash memory.
Downloading Application Files via TFTP
³ To download application file via TFTP:
1. From the Boot Manager menu, select System Configuration.
2. Configure the IP parameters of RICi-622GE (IP address, IP mask and default
gateway). These parameters are valid only for the TFTP file transfer via the
Boot Manager and can be changed later.
3. Reset RICi-622GE
4. Start a TFTP application.
5. Configure the connection timeout of the TFTP server to be more than
30 seconds to prevent an automatic disconnection during the backup
partition deletion (about 25 seconds).
6. Select a local software release file to download.
7. Enter the TFTP server address.
8. Start downloading.
RICi-622GE automatically erases the backup partition (it takes about
25 seconds). Once the downloading is completed, RICi-622GE saves the new
release as an active partition, and the former active partition becomes the
backup.