Specifications

Appendix B Boot Sequence and Downloading Software Installation and Operation Manual
B-2 Transferring Software Files RICi-622GE Ver. 1.0
Boot Version 1.01 (Oct 10 2007)
Boot Manager Version 10.07 (Oct 10 2007)
0 - Exit boot-manager
1 - Dir
2 - Set active software copy
3 - Delete software copy
4 - Download boot manager or an application by XMODEM
5 - Format Flash
6 - Show basic hardware information
7 - Reset board
8 - System configuration.
9 - Download boot manager or an application by TFTP
Select:
Figure B-1. Boot Manager Menu
From the Boot Manager menu, you can:
• List all files stored in the flash memory
• Delete the operating file; the backup file becomes the operating file
• Download a new operating file (via XMODEM or TFTP); the previous operating
file is saved as the backup file
• Display the basic hardware information (RAM, ROM size etc)
• Reset the RICi-622GE device
• Configure the RICi-622GE IP address, IP mask, and default gateway for the
consecutive file download via TFTP.
If you choose to exchange or delete a file, you are prompted for confirmation.
B.2 Transferring Software Files
New software releases are distributed as separate files, which are downloaded to
RICi-622GE using the XMODEM protocol or TFTP from the Boot Manager menu.
Alternatively, you can download a new software release via TFTP, when the
RICi-622GE management software is already running (Main menu > File Utilities).
Downloading Application Files via XMODEM
Downloading application files using the XMODEM protocol is performed from the
Boot Manager menu.
³ To download application file via XMODEM:
1. Configure your ASCII terminal or terminal emulation utility running on your PC
to the 115.2 kbps data rate.
2. Access the Boot Manager menu.