Specifications

Installation and Operation Manual Chapter 6 Troubleshooting and Diagnostics
RICi-622GE Ver. 1.0 Testing RICi-622GE 6-23
³ To run a loopback:
1. From the Diagnostic SDH/SONET menu (Diagnostic>Physical
Layer>SDH/SONET), select Interface.
2. Select the port for which to run the loopback.
3. From the Interface menu, configure the following:
 Test – Specifies the type of loopback that you wish to run (No Test, Local
Loopback, or Remote Loopback)
 Timeout – Specifies the period of time after which the loopback is
automatically disabled.
RICi-622GE
Diagnostic>Physical Layer>SDH/SONET>Interface
1. Port > (Link-1)
2. Test > (Remote Loopback)
3. Timeout > (Infinite)
>
Please select item from 1 to 3
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 6-23. Diagnostic SDH/SONET Menu
³ To disable diagnostic loopback:
• From the Diagnostic SDH/SONET Interface menu (Diagnostic > Physical Layer
> SDH/SONET > Interface), select Test and set it to No test.
Running a Ping Test
You can ping a remote IP host to check the IP connectivity.
³ To ping an IP host:
1. In the Main menu, navigate to Diagnostics > Ping Test > Ping.
The Ping menu appears as illustrated in
Figure 6-24 .
2. In the Ping menu, configure the following:
 Destination IP Address. This is the IP address of the host that you intend
to ping. Use values between 0.0.0.0 and 255. 255. 255. 255.
 Number of Frames to Send. Select 0 to send a continuous stream of
frames, or 1-50 to send a specified number of frames.
3. To start sending pings, select Send Ping.
The results are displayed in the lower scrolling message window.